A&S
Home > News > How to Replace Your Vehicle's Fuel Filter?

Air filter

Hydraulic Filter

Industrial Filter

Fuel Water Separator

Tanker truck filter

Garbage truck filter

Refrigerated truck filter

Light duty truck filter

Medium duty truck filter

Motor Coaches filter

Semi-truck filter

Motor Home filter

Septic pump truck filter

Van filter

Pickup filter

Auto filter

Fire truck filter

Membrane Element

Reverse Osmosis Filter

Diesel Fuel Filter

Fuel Filter

Fuel Pump Filter

Gas Filter

Dust Collector

Transmission Filter

Magnetic Filter

Air Compressor Filter

Carbon Dioxide Filter

Air Compressor Water Separator

Filter Material

Filter Paper

Filter Element

Tipper truck filter

How to Replace Your Vehicle's Fuel Filter?

How to Replace Your Vehicle's Fuel Filter
Here are instructions for replacing a fuel filter. Before you get started, read them carefully and believe that you can do it by yourself.
1.Relieve the pressure in the fuel line before disconnecting it. To do so, you have to disable the electric fuel pump before you start the engine.
To disable the fuel pump, you should do the following:
(1) With the engine off, remove the fuel pump fuse from the fuse box.
(2) Ensure that the parking brake is on and that the vehicle is in Park or Neutral, and then start the engine. It won't run very long after you start it up, but the pressure in the fuel lines will be reduced.
(3) Turn off the engine. With the fuel pump disabled, you're going to disconnect the fuel lines from the filter.
2. Look at the old filter and the new one before disconnecting anything.
You should see an arrow stamped on both filter that shows in which direction the fuel flows through it. If the new one doesn't have an arrow on it, look to see in whaat direction the old filter is installed so that you can tell which end of the new filter goes where.
3. Remove whatever is holding the old filter in place and remove it.
4. Put the new filter on in the same position as the old filter.
5. Replace whatever holds the filter in place, and ensure it's secure.
6. Replace the fuse for the fuel pump in the fuse box.
Lastly, make sure that the parking brake is on and that the vehicle is in Park or Neutral, and then start the engine and check for leaks around the filter.

Please Complete the short form below and a A&S sales representatives will contact you shortly. Note: Fields labeled with a * are required.
* Product:
* First Name:
* Last Name:
* Company:
  Phone:
   Fax:
*  Email:
*  Inquiry / Comments
*  Code
 
page run: 39.1 ms